My scores

Navy Physical Readiness Program

Navy BCA calculator

The Navy body composition assessment (BCA) has two steps. Step 1 divides your waist by your height, with height rounded up and waist rounded down to the half inch and the ratio cut to four decimals: at 0.5499 or less you are within standards. At 0.5500 or more, Step 2 reads an estimated body fat percentage from the PRP Guide-4 tables by sex, weight and height minus waist; the limit is 26% for men and 36% for women.

PRP Guide-4 (June 2026), for the 2026 PFA cycles · checked

To be within Navy BCA standards

  • 0.5499 or less waist-to-height ratio (WHtR) in Step 1, cut to four decimals
  • 26% or less body fat for men, 36% for women, in Step 2 at 0.5500 or more
  • No age adjustment in either step

Check your measurements

Step 1 Height and waist

Waist at the navel inches

Enter both readings, or one value to use for both. Each is rounded down to the half inch; height is rounded up.

Step 2 Needed only at 0.5500 or more

Sex

Rounded to the nearest pound, with nothing taken off for clothing.

Your BCA result

—

Not checked yet

Enter your height and waist to see your Step 1 ratio and whether it is 0.5499 or less.

Not an official result. Two Command Fitness Leaders measure you, record the BCA on NAVPERS 6110/10 and enter it in PRIMS.

Fills in sample measurements, clearly marked as an example.

How the two steps work

Step 1 divides your rounded waist by your rounded height. The result is cut, not rounded, to four decimals: a 38-inch waist at 70 inches gives 0.542857…, recorded as 0.5428. At 0.5499 or less you are within standards and Step 2 is not needed. At 0.5500 or more, Step 2 decides; a ratio over the line is not a failure on its own.

Step 2 subtracts your waist from your height and reads an estimated body fat percentage at your weight from Guide-4 Table-2 for men or Table-3 for women. At 26% or less for men, or 36% or less for women, you are within standards; above that, the BCA is not within standards. Step 1 is the same for everyone, Step 2 is the only place where sex matters, and neither step changes with age.

The calculator at the top runs both steps on your numbers. It shows the height and waist as recorded, the ratio, the table and page the percentage comes from, and the largest waist within Step 1 for your height.

How you are measured

  • Height. Shoes off and socks on, standing at attention with the head level, measured to the closest part of the scalp. The exact height is written down, then rounded up to the next half inch: 65.25 inches becomes 65.5.
  • Waist. On bare skin at the navel, starting from the right side, with the tape parallel to the deck, at the end of a normal breath. Two readings are taken, each rounded down to the half inch. If they differ by more than an inch, a third is taken, and the two closest are averaged and rounded down again.
  • Weight. In the PT uniform with shoes off, to the nearest pound, a half pound or more going up. Nothing is taken off for clothing. Everyone is weighed, but only Step 2 uses the weight.

Measurements are taken in the Navy PT uniform (PTU or OPTU). Control-top hose, leggings and other shaping garments are not allowed.

Guide-4 gives its own example: readings of 34.25, 32.5 and 32.25 inches round down to 34, 32.5 and 32. The two closest, 32.5 and 32, average 32.25, which is recorded as 32 inches. The guide prints that average as 32.253, a typo for 32.25.

Guide-4 does not say what is recorded when two readings are within an inch of each other but not equal. The calculator averages them and rounds down, and says so in the result: readings of 34 and 34.5 inches are recorded as 34. To decide whether a third reading is needed, it compares the rounded readings, as the guide’s example does.

Rounding height up matters at the line. At 65.25 inches with a 36-inch waist, height is recorded as 65.5 and the ratio is 0.5496, within standards. With height rounded down to 65 inches, as another document does, it would be 0.5538; which rules this follows explains what the calculator shows then.

Maximum waist for your height

Guide-4 Table-1 gives, for every height from 48 to 83.5 inches, the largest waist in half inches that keeps Step 1 at 0.5499 or less, the same for men and women of every age: at 6 feet, 72 inches, the maximum is 39.5 inches. The whole table, row by row, is on Navy height and weight standards, and the calculator’s result links to your row there. A waist above your row does not fail the BCA; it sends you to Step 2.

How Step 2 reads body fat

Step 2 uses the same rounded height and waist. Height minus waist gives the height-waist difference. Find your weight, rounded to the nearest pound, in the columns of the table for your sex, and the difference in the rows; the cell is your estimated body fat percentage, a whole number used as printed.

For example, a man 70 inches tall with a 39-inch waist has a ratio of 0.5571, so Step 2 decides. His height-waist difference is 31 inches; at 185 pounds, Table-2 on page 15 of Guide-4 reads 23%, under the men’s limit of 26%, so he is within standards.

  • Table-2, men: 101 to 380 pounds, pages 11 to 24 of Guide-4. The limit is 26%.
  • Table-3, women: 61 to 300 pounds, pages 25 to 36. The limit is 36%.

Each block of 20 weights prints its own range of height-waist differences, so what fits in the table depends on your weight. When the weight or the difference falls outside the printed table, the Command Fitness Leader records the raw measurements on NAVPERS 6110/10, and the official percentage is calculated in PRIMS, the Physical Readiness Information Management System, before you take the PRT. Guide-4 does not publish the formula PRIMS uses, so the calculator gives no percentage there; it tells you that the official number comes from PRIMS.

The ratio is not body fat

The Step 1 ratio is one length divided by another. It has no percent and does not convert to one: 0.5500 is not 55% or any other body fat figure. Only Step 2 gives a percentage, and that number is an estimate read from the Navy’s tables, not a measurement of your body.

Body fat calculators that ask for your neck, your hips or your age follow other methods. The BCA in Guide-4 uses only height, waist and weight, and allows no substitute: no underwater weighing, skinfold calipers, body mass index or bio-impedance. A percentage from those tools is not a BCA result.

If you are not within standards

Under PRP Guide-1, a BCA that is not within standards fails the whole physical fitness assessment (PFA), with one exception. You still take the PRT, after a medical provider clears you through the PARFQ.

  • High-Performance BCA Exemption. If you score Outstanding-Low or better overall on the PRT, with no event below Excellent-Medium, the PFA counts as a pass. The BCA is still recorded as not within standards, and you still enter the Fitness Enhancement Program (FEP). You must take and pass all three events: a medical waiver from any one of them rules the exemption out, and it does not apply in units that elect to DEP/OP the PRT. When you meet the criteria, your commanding officer cannot refuse it.
  • Records. Enlisted Sailors receive a Page-13 and officers a Letter of Notification. The failure goes into the EVAL or FITREP, which also shows whether the BCA was within standards.
  • Advancement. After a failed most recent PFA, you cannot be promoted, advanced or frocked until you pass the next official PFA, or a Special PFA your commanding officer approves.
  • Separation. Three PFA failures in the most recent four years lead to processing for administrative separation.
  • FEP. In the program you weigh in every week, and a BCA is done only at the monthly unofficial PFA. You leave it by passing an official PFA: the BCA within standards and Good-Low or better in every PRT event you are cleared for, or Good-High in combat arms.

NAVADMIN 264/25 reset failures before January 1, 2026 to zero for reenlistment, advancement, promotion and continuation; other programs may still count them. Under OPNAVINST 6110.1L, the exemption does not apply to new accession Sailors. PRT scores are on the Navy PRT calculator, and the levels by age and sex on the Navy PRT standards page.

When the BCA is taken

  • Cycles. In 2026 there are two PFA cycles, January 1 to June 30 and July 1 to December 31. Active duty Sailors complete two assessments a year, reservists at least one.
  • Timing. The BCA comes within 45 days before the PRT, and at least 24 hours before it.
  • One official BCA. Once the command’s PFA cycle has begun, the first BCA is the only official one, and retests are not allowed. The result is final; a later medical waiver does not reverse it.
  • Who measures. At least two certified Command Fitness Leaders or trained assistants (CFL and ACFL), who sign NAVPERS 6110/10, the BCA score sheet. One-on-one measurements are not allowed, and you are not entitled to a measurer of your own sex, although commands are encouraged to have both.
  • Who takes it. Every Sailor, even one who cannot take the PRT, unless medically waived or exempted for pregnancy or postpartum.
  • Altered measurements. If the CFL sees signs that you tried to alter a measurement, you are turned away for at least 72 hours.

NAVADMIN 264/25 announced the two-step BCA without a start date of its own; this page applies it to the 2026 PFA cycles.

Which rules this follows

The calculator follows PRP Guide-4 as written, in its June 2026 edition. DoW Instruction 1308.03, the Department of War’s fitness and body composition instruction, took effect on August 31, 2026 and sets some steps differently. We found no Navy document that reconciles the two. Where they differ:

  • Height rounding. Guide-4 rounds height up to the half inch; DoWI 1308.03 rounds measurements down. When your height is not a whole half inch and the two roundings end in different results, the calculator shows both instead of a single verdict.
  • Waist site. Guide-4 measures at the navel. DoWI 1308.03 measures midway between the lowest rib and the top of the hip bone, which it says is typically at or just above the navel. The calculator uses the waist you enter; it cannot tell where it was taken.
  • Height landmarks. Guide-4 measures in socks to the closest part of the scalp; DoWI 1308.03 measures from the soles of the feet to the top of the head. The difference is a fraction of an inch, which changes a result only right at a half-inch step.
  • The line. DoWI 1308.03 sets a ratio below 0.55 without stating decimals. Guide-4’s 0.5499 or less, cut to four decimals, is the same line, and both send 0.55 or more on to body fat.
  • Body fat. DoWI 1308.03 names no method and lets each service set its limits, no stricter than 18% for men and 26% for women and no looser than 26% and 36%. The Navy’s limits sit at the loose end, and the tables are the Navy’s own.

This page covers Sailors in the PFA; combat arms Sailors take the BCA in their combat fitness assessment as well. Standards for joining the Navy come from the Navy Recruiting Manual; they are summarized under joining the Navy.

Sources

Checked October 25, 2026. Table-1 and the body fat tables come from the first document below; the rules come from the others.

  • PRP Guide-4, Body Composition Assessment (BCA) (June 2026): Sections 1 to 3, Table-1, Table-2 and Table-3
  • PRP Guide-1, PRP Policies (August 2026), paragraphs 6 and 8 to 10
  • FY26 Physical Readiness Program FAQ (updated October 7, 2026), for uniform, FEP and the exemption
  • NAVADMIN 264/25 (December 30, 2025), paragraphs 2, 3, 6 and 8, and its fact sheet
  • DoW Instruction 1308.03, DoW Physical Fitness/Body Composition Program (August 31, 2026), paragraph 3.2.g

The rule on new accession Sailors comes from OPNAVINST 6110.1L, Physical Readiness Program, paragraph 3.b; we read an archived copy of it. How this site turns official tables into its own is described in how we score.

Questions

Does the Navy still use BMI or a height and weight chart?

No. Guide-4 allows no body mass index or other substitute method, and there is no maximum weight for a height. Weight matters only in Step 2, together with your height and waist; the one chart by height is Table-1, the maximum waist, on Navy height and weight standards.

What happens if my ratio is 0.5500 or more?

Step 2 decides. Your height minus waist and your weight give an estimated body fat percentage from Table-2 or Table-3, and at 26% or less for men or 36% or less for women you are still within standards.

What happens if I fail the BCA?

The whole PFA fails unless you qualify for the High-Performance BCA Exemption, and you enter the FEP either way. A failed PFA also brings a Page-13 or Letter of Notification, a note in your EVAL or FITREP and no advancement until you pass again; three failures in four years lead to separation processing.

Are the standards different for women or by age?

Step 1 is the same for everyone. Step 2 uses a separate table for women, with a limit of 36% instead of 26%. Neither step changes with age.

Can I be measured again?

Not in the same cycle. The first official BCA is the only one, and a later medical waiver does not reverse it. The only wait Guide-4 sets is 72 hours, for a Sailor turned away after trying to alter a measurement.

Is this a body fat calculator?

Only in Step 2, and only as far as the Navy’s own tables go. The Step 1 ratio is not a percentage, and the calculator gives no percentage outside the printed tables or from the neck or hips.

Is this my official result?

No. Your official BCA is the one two CFLs record on NAVPERS 6110/10 and enter in PRIMS. This page shows how those steps work out for your own numbers.